Brilliant Idea…I hope so…Wires on parade…

    When one is working on a stumpwork project wires go haywire. You are using them for shaping a leaf or other wonderful objects to add to your embroidery. The ends are long! Remember these wires will be pulled to the  back later on..Whilst stitching a number of objects for stumpwork these wires catch the thread, then fray and basically drive one nuts because it stops the lovely thread from sliding through the fabric with ease. (Made me think of the scene in “Sleeping Beauty” where the Prince is hacking through the thorns!) Now here are my two solutions to the problem. (By the way knots happen too!) I am sure there are many other solutions out there but so far this works! 

First  take a pencil or other round object and wrap the wire around it like so….

Next press it flat gently near the object one is working on. 


    Then you can either place a piece of “Glad Press and Seal” over the the wire or you can use “Painters Tape”..just to hold it in place and keep any thread you use from catching whilst one is working. Ahhh…blessed relief! Mainly I use the “Press n Seal” when I have a whole bunch done and want to protect the stitching and then the painters tape when I am working on one so now “that dag nabit” wire is no longer in the way. Now I can move onto the next object! As for leaving any kind of residue since you trim these out your good to go. I have used “Painters Tape” for many years and have yet to have it cause any problems for me. I still am careful where I use it so my go to is still the “Glad Press n Seal”. These products are just tacky enough and have found there to be no pulling on any of the stitching that I do. What is nice though it will just grab the “hairs” that might get on ones project and also some of the bits of loose threads left behind.

     
I’ve been accused of thinking to much…well sometimes I am glad I do! 

4 thoughts on “Brilliant Idea…I hope so…Wires on parade…

  1. Catherine

    They are some very clever solutions! The wires drive me nuts when working lots of different elements. I usually try taping the wires down, but it never works well. I will give this s go!

    Reply

Love to hear comments...thanks!